Welcome to Infoblox NetMRI Community Sign in | Join | Help
in Search
Home Blogs Support Forums Downloads www.infoblox.com
Infoblox NetMRI Community » NetMRI » General Discussion - NetMRI » Cisco Command Tool and ASA

Cisco Command Tool and ASA

Last post 09-13-2010 1:55 PM by mccamish. 2 replies.
Page 1 of 1 (3 items)
Sort Posts: Previous Next

  • 08-18-2010 9:40 AM

    Cisco Command Tool and ASA

    Reply Contact

    I've been trying to run a command (sh vers) on our ASA (Version 8.3(2)), and it's not working the way I expect. NetMRI version is 4.2.2.45.

    If I leave the "Login Mode" set to automatic, it fails with the error "Command Failed".  The output shows that netmri logs in, sends the enable command, then doesn't get to enable mode.

    If I set the login mode to manual, and don't enter the enable password, the command succeeds.

    The enable password is correct, as I'm able to "get configs" successfully.

    Any suggestions?

     

  • 08-20-2010 5:28 AM In reply to

    Re: Cisco Command Tool and ASA

    Reply Contact

    I have the same problem. Not only with PIX/ASA but also with FWSM

  • 09-13-2010 1:55 PM In reply to

    Re: Cisco Command Tool and ASA

    Reply Contact

    Upgraded to NetMRI version 4.3.1.15, still fails.  Anyone have any suggestions?
Page 1 of 1 (3 items)
© 2010 Infoblox Inc. All rights reserved. All registered trademarks are property of their respective owners. | www.infoblox.com